Precision
Micropositioners
The Charles Supper Company micropositioners are the smallest and most varied group of standard products available for performing precise manual adjustments. They can be designed into new instruments and assemblies or be readily adapted into existing ones.
Key Features
- Permit fine-tuning positioning
- Durable aluminum construction with hardened stainless steel drive screws and permanent lubrication
- Supplied with a drive key for adjusting and locking each motion into position
- Drilled and tapped holes are provided for versatile mounting arrangements
- X-Y Micro-Slides, Micro-Goniometric Arcs
X-Y Micro-Slides
| Featuring three sizes ranging from .500"sq. with 0.125" X-Y travel to
1.4990" O.D. with .750" X-Y travel, each translational sledge may be fully
locked. For mounting, one sledge has two drilled and tapped holes and
the second has two holes countersunk on the inner side.
|
|
|
"Z" Attachments
| Offered for use with our Model
2201 X-Y Micro-Slides to provide 1/8" Z travel. A mounting hole with
a set-screw to hold mirrors and other devices is provided.
|
Micro-Goniometric Arcs
| Designed with threaded holes to
accept mirrors and other devices, the position of arc may be read to 5
minuutes using a vernier scale. They come in two sizes with up to
±25° arc travel and vernier position can be
locked in place without loss of setting. Mounting holes are located in the vernier top and base. These arcs may be used individually, concentrically stacked (common center is achieved if two sizes are stacked with the smaller size on top). They may be stacked with our X-Y's.
|
